Mustang Survival Life Jacket MA7214 User Manual

Inflatable PFD Re-Arm Kit MA7214  
WARNING  
tube and check that it stays inflated at least overnight.  
Empty the Inflatable PFD again by reversing the oral-  
inflation tube dust cap and inserting it into the valve.  
Gently squeeze the inflatable PFD until all air or gas has  
been expelled. Let the Inflatable PFD dry before packing.  
IMPORTANT: Ensure all air is removed before repacking.  
WATER  
INLET VALVE  
·
·
Use only with specified PFD models.  
This gas cylinder is under pressure, therefore misuse can  
be dangerous.  
SINGLE  
POINT INDICATOR  
·
Do not incinerate, expose to sunlight or store above 120˚F  
(50˚C).  
Re-arm kit for Mustang survival Models:  
Trousse de réarmement pour les modèles de V.F.I.  
de Mustang survival:  
13 Refold the Inflatable PFD in accordance with the repacking  
section in the PFD manual.  
CAP  
Figure 3  
Figure 7  
·
·
·
·
Do not throw into open fire or dump at sea.  
Keep away from children.  
4 Squeeze the sealing ring to elongate and remove the  
inflator body through the sealing ring (Fig. 4).  
8 Hold the CO cylinder through the fabric of the Inflatable  
Dispose of gas cylinders only when empty.  
Discharge and dispose of corroded or rusty cylinders.  
2
MD3183, MD3184, MD3188  
MD3153, MD3154  
PFD (Fig 8a). Position the replacement cap with the water  
inlet valve pointing to the right and press firmly onto the  
inflator body and sealing ring (Fig. 8b).  
IMPORTANT: Please review and follow additional  
maintenance instructions in your manual.  
RED  
INDICATOR  
INFLATOR BODY  
Re-arming instructions  
90º  
1 Place the Inflatable PFD  
(Personal Flotation Device)  
on a smooth, flat surface  
and wipe off any water.  
If needed, unpack the  
SEALING RING  
Figure 4  
PFD starting at the zipper  
flap. Access the inflator  
by reaching between the  
cover and cell and pull it  
toward you, turning the  
cell and cover inside out to  
fully expose the inflator for  
Figure 8a  
Figure 8b  
5 Dispose of the used inflator body (Fig. 5).  
9 While pressing FIRMLY onto the inflator body, turn the  
BLACK locking ring clockwise into the locked position (Fig.  
9). Pull on the cap to make sure it has locked onto the  
inflator body.  
RED INDICATOR  
re-arming. Hold the CO  
2
cylinder through the fabric,  
using one hand (Fig. 1).  
TRASH  
Figure 1  
Figure 5  
2 Insert the metal key between the black locking ring and  
labeled yellow cap. Turn the key counter-clockwise (Fig. 2).  
6 Check that the new inflator body indicator is green. Insert  
BLACK  
LOCKING RING  
the new inflator body with CO cylinder pointing upward  
inside the Inflatable PFD. Let the sealing ring rest on the  
adapter around the four lugs (Fig. 6).  
Figure 9  
2
10Check: To see that the single point status indicator on the  
cap is green; the pull to inflate lanyard is present and that  
the locking ring is locked.  
GREEN  
CAUTION:  
DO NOT TURN  
THE CENTER  
SHAFT  
INDICATOR  
11Turn cell and cover right-side out, returning to normal  
state. If your PFD has the black molded inflator cap cover  
(see Fig. 10), position the protective inflator cap cover  
LOCKING RING KEY  
Figure 2  
over the inflator body so  
that the single point status  
Inflator  
Cap Cover  
Figure 6  
3 Turn the black locking ring counter-clockwise and lift off  
the cap (yellow inflator operating head Fig. 3). Dispose of  
the used cap.  
indicator is visible thrrough  
the inflator cap cover  
window.  
7 Now check the new manual/automatic cap as follows (Fig. 7):  
1. Is the single point status indicator showing green?  
2. Is the expiry date OK?  
Single Point  
Status Indicator  
12 If your Inflatable PFD has  
Inflator Cap  
Cover Window  
If YES is the answer to both questions, then proceed as  
follows. If the answer is NO to either question, get a new cap.  
been used and/or the  
inflator replaced, always  
inflate through the oral  
Figure 10  
 
PA7214_Rearm_12Aug2009.indd 1-5  
8/25/2009 4:34:07 PM  

Murphy Network Card RTDT Series User Manual
National GPS Receiver ADC12010 User Manual
National Instruments Network Card NI USB 6008 User Manual
NEC Flat Panel Television M40 2 AVT User Manual
Nikon Camera Accessories EN EL4a User Manual
Omega Stud Sensor DMD 476 User Manual
Omega Vehicle Security Scanner DPS3300 User Manual
Parkside Grinder PWS 230 SE User Manual
Parkside Sander PEBS 900 SE User Manual
Patton electronic IP Phone SmartNode 4110 Series User Manual